Into setting

When meter working, press [PAG], it will display “ Menu choose Set P1”, then press [MOV], it will show “Lower limit  00000”, you will start to change the parameter, the parameter will display as below, one by one

Lower limit

Low Limit, if the meter don’t have the relay function, press [PAG] to next parameter

Upper limit

High Limit, if the meter don’t have the relay function, press [PAG] to next parameter

Current mode

Work pattern, pre-set:MOD-S. press [PAG] to next parameter

Difference

It is used to set the measure pattern

1. if set the value as zero, it will display the value of the distance from the sensor to the target

2. if set the value as the height of sensor, from the sensor to the bottom, but it could not excced the measure range; meter will display the value from the surface to the bottom

When display “Difference 00000”, press [ADD] and [MOV], set suitable value; when the final digit is flashing, press [MOV ] again, the meter will save the setting; the setted value will display on the left…press [PAG] to next parameter

Address

communication address, press [ADD] and [MOV], set suitable value; press [PAG] to next parameter

Baud rate

Similar as the above。

Emission power

For ultrasonic emission power, the value could be 1-20, pre-setted

quit

Press [PAG] more than 3 second, quite parameter setting。